BRASS
HANDLE END CAPS BRASS END CAPS |
|
|
|
Made to fit our standard trunk handles,
1.25" wide, either with or without
slots. These should be used with
handles that have slots in them in order
to allow the handle to slide back and
forth in the bracket, which allows the
handle to lay flat against the side of
the trunk when not in use.
HANDLE
BRACKETS OR LOOPS WITH PINS
brass finish, with pins (also available
in antique brass finish - see below)
These
brass-finish brackets fit over slotted
handles like the ones shown above.
Takes four nails to attach each loop,
so you need a total of 16 nails to do
one trunk. Note that the handles
don't need to be nailed to the trunk if
you use these loops, the pins under the
loops hold the handles in place, and the
slots allow the handle to lay flat against
the trunk when not in use. Slick.
Same Brackets - Antique
Brass Finish These fit in a little better
on old trunks.
Set
of 4 Antique Brass Bracets with Pins
Handle Loop Brackets
with No Pins
These babies fit over wide-end trunk handles
like our TH-02 handles. Total of
sixteen nails required to attach four
loops to a trunk. The handles themselves
do not need to be nailed to the trunk;
the loop holds the handle in place.
The handles can move within the loop,
so they lay flat against the trunk when
not being gripped. These are brass-plated
steel, available in either bright brass
or antique brass finish.
These are smaller loops, often used on
doll trunks or smaller boxes. They'll
accept a handle that is no wider than
7/8" and no thicker than 3/8".
Brass finish, but not too terribly shiny.
Attach with nails only because if you
use screws strange voodoo things may happen
to your trunk.
|